5 Series E60 520d (M47T2) SAL
12 51 200
Replacing wiring harness section for injectors
(M47T2)
Necessary preliminary tasks:
•
Read fault memory of DDE control unit
•
Switch off ignition
•
Disconnect battery negative lead
•
Remove acoustic cover at front and rear
Unlock cover (1) with slide (3).
Unfasten screws (2).
Remove electronics box cover (1).
Unlock and remove cover (1).
Unlock and raise control unit (2).
Unlock connector and remove.
Pull profile seal of wiring harness out of electronics box.
Installation:
To prevent leaks, you must install profile seals correctly.
Withdraw lock (1).
Press out plug (2) in direction of arrow.
RA Replacing wiring harness section for injectors (M47T2)
BMW AG - TIS
22.01.2013 20:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
