5 Series E60 520d (M47T2) SAL
Check auxiliary damper (1) with protective tube and spring
pad (2) for damage, replace if necessary.
Attach support pot to piston rod.
Replacement only: Carry over marking from old part to new part.
Insert shock absorber in tensioned coil spring.
Check support bearing for damage, replace if necessary.
Attach support bearing and plate to piston rod.
Replace nut and tighten down (gripping piston rod in so doing).
Tightening torque 33 52 2AZ
.
Important!
One threaded pin (1) on the thrust bearing must be on one
plane with the bore in the rubber mount (2) and the opposite
side of the bush (3).
RA Replacing rear left or right spring strut shock absorber
BMW AG - TIS
22.01.2013 22:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
