5 Series E60 520d (M47T2) SAL
Release nuts (1, 2) (pressure lines to rear axle oscillating motor).
Tightening torque 37 14 12AZ
.
Release nut (3) (return line)
Tightening torque 37 14 19AZ
.
Release nut (4) (pressure line)
Tightening torque 37 14 16AZ
.
Release nuts (5, 6) (pressure lines to front axle oscillating motor).
Tightening torque 37 14 15AZ
.
Installation:
Make sure hydraulic lines are laid without tension and with
sufficient spacing to adjoining components.
Partially detach front right wheel arch trim.
Disconnect plug connections (1, 2).
Remove grounding strap from valve block.
Release screws (3).
Tightening torque 37 14 17AZ
.
Raise valve block and remove towards front.
Disconnect all plug connections (1) on valve block.
Unclip wiring set from valve block.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
•
If necessary, carry out initial Dynamic Drive operation
RA Removing and installing/replacing DYNAMIC DRIVE valve block
BMW AG - TIS
22.01.2013 22:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
