5 Series E60 520d (N47) SAL
32 13 650
Removing and installing/replacing EH
converter for Servotronic
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Necessary preliminary tasks:
•
Remove reinforcement plate
•
If necessary, remove heat shield.
Disconnect plug connection (1).
Unfasten screws (2).
Remove EH converter (3).
Installation:
Clean side return orifice with compressed air.
Align EH converter (3) to opening in power steering gear, press
by hand into power steering gear up to stop, insert screws (2)
and tighten down.
Tightening torque 32 13 12AZ
.
After installation:
•
Fill and bleed hydraulic system
Version with Dynamic Drive:
•
If necessary, carry out initial Dynamic Drive operation
RA Removing and installing/replacing EH converter for Servotronic
BMW AG - TIS
23.01.2013 18:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
