5 Series E60 520d (N47) SAL
34 21 745
Removing and installing or replacing left or
right rear brake caliper
Necessary preliminary tasks:
•
Remove wheels
Observe safety instructions on raising the vehicle.
After completing work: Bleed braking system
Press clutch pedal down to floor and secure with pedal support.
Note:
The pedal support may only be released when the brake lines are
reconnected.
This prevents brake fluid from emerging from the expansion tank
and air from entering the system when the brake lines are opened.
Right side: Disconnect plug connection for brake lining wear
sensor.
Release screws (1).
Installation:
Tightening torque 34 21 3AZ
.
Disconnect brake hose (2).
Installation:
Tightening torque 34 32 5AZ
.
Unfasten brake hose at connection point to brake line.
Tightening torque 34 32 1AZ
.
First tighten the brake hose on the brake cover, then tighten
connection on brake line.
Install brake hose without torsional stress.
Pull off fist caliper towards rear of vehicle.
RA Removing and installing or replacing left or right rear brake caliper
BMW AG - TIS
23.01.2013 19:48
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -