5 Series E60 520i (M54) SAL
24 13 013
Replacing output flange shaft seal
(GA6HP19Z)
Special tools required:
•
23 0 020
•
24 2 351
•
24 2 352
•
24 2 353
•
24 2 370
•
24 2 380
Important!
After completion of work, check gear oil level.
Use only the approved gear oil.
Failure to comply with this requirement will result in serious
damage to the automatic transmission!
Necessary preliminary tasks:
•
Remove rear underbody protection.
•
Remove exhaust system after catalytic converter.
•
Remove transmission cross-member.
Release screws and remove transmission support block (1) (if
fitted).
Tightening torque 24 71 6AZ
.
RA Replacing output flange shaft seal (GA6HP19Z)
BMW AG - TIS
24.01.2013 17:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
