5 Series E60 520i (M54) SAL
Attach special tool 51 3 010 twice to tool trolley. Moisten suction surfaces and tension windscreen from outside.
If reusing the removed windscreen, remove adhesive residue down to 0.5 mm and press expanding foam tape down
with hand roller.
Install rubber frame (6), paying attention to centre marking on rubber frame and mirror base.
Virtually vertical part (B) of adhesive bead (1) must be positioned to window edge (5) or rubber frame (6).
Markings (G, H) are on windscreen in bottom corners. Apply primer or adhesive at correct distance to windscreen
edge (5) (wind noises, leaks).
Spread cement bead (4) with special tool 00 9 322 .
Note:
Adhesive area for plastic adhesive tapes (1) must be free from
grease and dust.
Stick two yellow plastic adhesive tapes (1) to roof at distance (A)
from outside corners.
Length: 400 mm
A= 250 mm
Working on windscreen (1) carefully with special tool 51 3 010 :
-
position at top
-
align sides evenly
-
insert at bottom and press down
-
press upwards until seal rests evenly on roof
-
secure in terms of height in this position at top with two yellow
plastic adhesive tapes (2)
Preload on top of windscreen to prevent wind noise:
Windscreen (1) must be lower than roof outer skin (2). This is
the only way to prevent wind noises.
Position special tool 51 0 010 in middle of vehicle depending
on measurement (A) and check underprotrusion of
windscreen (1).
Windscreen underprotrusion (A):
A= 3.2
±
1 mm
X = Measurement stages 1 ... 4 mm
RA Removing and installing/replacing windscreen
BMW AG - TIS
24.01.2013 21:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -