5 Series E60 520i (N46T) SAL
Relieve tension on knurled screw (2) on special tool 11 9 301 .
Release screw (1) and remove special tool 11 9 301 .
Release special tool 11 9 303 .
Remove special tool 11 9 302 .
Lift out inlet camshaft (1).
If necessary, replace plain compression rings (1).
Important!
Plain compression rings (1) can easily break.
Plain compression rings (1) are engaged at joint.
Press compression ring (1) on one side into groove, pull up on
other side and unhook catch.
Carefully pull compression ring (1) apart and remove towards
front.
Clean all bearings and cams of inlet camshaft and lubricate with
engine oil.
RA Removing and installing/replacing inlet camshaft (N46T)
BMW AG - TIS
26.01.2013 18:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 9 -