5 Series E60 520i (N46T) SAL
Pretension clamping rail by turning adjusting screw with special
tool 00 9 250 or commercially available torque wrench to
0.6 Nm .
Tighten down screw (1) of exhaust adjustment unit.
Tightening torque 11 36 1AZ
.
Tighten down screw (2) of inlet adjustment unit.
Tightening torque 11 36 1AZ
.
Remove all special tools.
Install chain tensioning piston.
Crank engine at central bolt twice in direction of rotation until
engine returns to firing TDC position of 1st cylinder.
Resecure flywheel.
RA Adjusting camshaft timing (N46T)
BMW AG - TIS
26.01.2013 18:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -