5 Series E60 520i (N46T) SAL
21 00 006
Bleeding clutch hydraulics (plastic slave
cylinder)
Necessary preliminary tasks:
•
Remove underbody protection from transmission.
Connect bleeder unit to brake fluid expansion tank.
Important!
Check relevant Operating Instructions for each device.
Charging pressure should not exceed 2 bar.
Connect bleeder hose to bleed valve (1).
Open bleed valve (1) and flush until clear brake fluid emerges
without air bubbles.
Close bleed valve.
Switch off bleeder unit or remove from brake fluid expansion tank.
Correct brake fluid level in expansion tank.
RA Bleeding clutch hydraulics (plastic slave cylinder)
BMW AG - TIS
26.01.2013 19:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -