5 Series E60 520i (N46T) SAL
If necessary, remove heat shield from power steering gear.
Release banjo bolts (1).
Disconnect pressure line and return line from power steering gear.
Installation:
Replace all sealing rings.
Make sure hydraulic lines are laid without tension and with
sufficient spacing to adjoining components.
Tightening torque 32 41 3AZ
.
Release screw (1).
Release nuts (2) and remove screws towards bottom.
Installation:
Replace screws and self-locking nuts.
Tightening torque 32 00 1AZ
.
Version with active steering:
Disconnect plug connections (1-4).
Raise power steering gear and unclip wiring harness.
Move power steering gear to right and remove towards rear.
RA Removing and installing/replacing power steering gear
BMW AG - TIS
26.01.2013 20:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -