5 Series E60 520i (N46T) SAL
Determine measurement (A) to simplify following adjustment of
front axle.
Release clamping nut.
Screw off tie rod end; if necessary, grip tie rod with open-end
wrench.
Installation:
Check gaiter for damage, replace if necessary.
Mount clamping ring (1).
Screw tie rod end onto tie rod to measurement (A).
Tightening torque 32 21 5AZ
.
After installation:
•
Perform chassis alignment check
•
Carry out steering angle sensor adjustment/adjustment for
active front steering
RA Replacing left or right tie rod
BMW AG - TIS
26.01.2013 20:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -