5 Series E60 520i (N46T) SAL
32 41 060
Removing and installing (replacing) vane
pump for power steering (N46T)
Warning!
Danger of poisoning if oil is ingested/absorbed through the
skin!
Risk of injury if oil comes into contact with eyes and skin!
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Close off pipe connections with plugs.
Recycling:
Follow instructions for working on cooling system!
Catch and dispose of hydraulic fluid in a suitable container.
Observe country-specific waste-disposal regulations
Necessary preliminary tasks:
•
Draw off and dispose of hydraulic fluid from fluid reservoir
•
Remove fluid reservoir with bracket from mounting bracket
•
Drain and dispose of coolant from radiator
•
Disconnect coolant hoses from thermostat housing and
thermostat
•
Remove radiator
•
Remove belt pulley
Release hose clamp (2) and detach suction line (1) from vane
pump.
Installation:
Markings on suction line and vane pump connection must match
up.
Lay fluid reservoir with bracket and hydraulic lines to one side.
Release banjo bolt (3) and disconnect pressure line (4).
Installation:
RA Removing and installing (replacing) vane pump for power steering (N46T)
BMW AG - TIS
26.01.2013 20:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
