5 Series E60 520i (N46T) SAL
11 12 Cylinder Head with Cover
Type
Thread
Tightening specification
Measure
1AZ Cylinder head bolts
(steel bolt)
N46T
M10x170
Replace screws
Jointing torque
30 Nm
1st angle of rotation
90
°
2. Angle of rotation
90
°
3. Angle of rotation
45
°
2AZ Cylinder head bolts
(steel bolt)
N46T
M9x95
M9x125
Replace screws
Jointing torque
30 Nm
1st angle of rotation
90
°
2. Angle of rotation
omitted
3. Angle of rotation
45
°
3AZ Cylinder head bolts to timing case,
front
N46T
M9x95
Replace screws
Jointing torque
10 Nm
Torque angle
90
°
4AZ Cylinder head cover to cylinder head
N46T
M6
10 Nm
5AZ Ignition coil cover to cylinder head
cover
N46T
10 Nm
7AZ Lifting lug to cylinder head
N46T
M8x22
22 Nm
8AZ Screw plug, oil duct, rear (exhaust-
gas side)
N46T
M14x1.5
Tapered thread, dry
35 Nm
9AZ Screw plug, oil duct, rear (inlet side)
N46T
M14x1.5
Tapered thread, oiled
30 Nm
10AZ Stud to cylinder head (exhaust
manifold)
N46T
M7x37
15 Nm
11AZ Outlet fitting to cylinder head
N46T
M6x25
9 Nm
12AZ Oil spray line
N46T
M7x16
Replace banjo bolt, seal
9 Nm
13AZ Screw plug near chain tensioner
N46T
M8x1
6.5 Nm
14AZ Screw plug, secondary-air pipe
N46T
M18x1.5
40 Nm
AZD Cylinder Head with Cover
BMW AG - TIS
27.01.2013 08:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
