5 Series E60 523i (N52) SAL
Unlock hydraulic lines (1 and 2) on heat exchanger (3) with
special tool 17 0 030 and disconnect.
Installation:
Connect hydraulic line (2) with TOP marking to upper pipe of
heat exchanger.
Release screws (1).
Remove heat exchanger (2) in direction of arrow.
Important!
Check fluid level in automatic transmission,
refer to Maintenance and General Information MG00.
Top up coolant and vent cooling system.
RA Removing and installing/replacing heat exchanger for automatic transmission
BMW AG - TIS
27.01.2013 21:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
