5 Series E60 523i (N52) SAL
Unfasten screws.
Installation:
Observe screw fastening sequence without fail.
Tightening torque, steel screws 23 00 1AZ
.
Aluminium screws must be replaced.
Tightening torque and angle of rotation
Aluminium screws 23 00 2AZ
.
Important!
Do not allow the transmission to hang off from the
transmission input shaft as this will deform the clutch plate.
Pull out transmission towards rear and remove.
Installation:
Secure angle of rotation special tool 00 9 120 with magnet
00 9 130 to floor plate. Screw down aluminium screws according
to angle of rotation.
Angle of rotation 23 00 2AZ
.
Installation:
Check that dowel sleeves are correctly seated.
Replace damaged dowel sleeves.
Ensure correct position of cover plate.
Installation:
Check lubrication of transmission input shaft for sticky
consistency. If grease is sticky, clean input shaft and replace
clutch plate.
Check clutch plate for friction rust in splines and replace if
necessary.
Mechanically remove existing grease and lining abrasion from
splines of clutch plate (with a cloth).
RA Removing and installing transmission (GS6-17BG)
BMW AG - TIS
27.01.2013 21:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
