5 Series E60 523i (N52) SAL
23 12 060
Replacing radial shaft seal for output flange
(GS6-17BG/DG)
Special tools required:
•
00 5 011
•
23 0 020
•
23 1 210
•
24 0 110
•
33 1 150
Important!
After completion of work, check transmission oil level.
Use only approved transmission oil.
Failure to comply with this instruction will result in serious
damage to the transmission.
Necessary preliminary tasks:
•
Remove underbody protection
•
Remove exhaust system
•
Remove front muffler (N45K)
•
Remove heat shields
•
Tie propeller shaft to one side.
Brace output flange with special tool 23 0 020 .
Release collar nut with special tool 23 1 210 .
Tightening torque 23 21 1AZ
.
Insert collar nut with Loctite 243 screw securing adhesive
(sourcing reference: BMW Parts Service).
RA Replacing radial shaft seal for output flange (GS6-17BG/DG)
BMW AG - TIS
27.01.2013 21:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -