5 Series E60 523i (N52) SAL
37 14 512
Replacing rear ride-height sensor
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Release nut and disconnect jointed rod (3).
Installation:
Replace self-locking nut.
Tightening torque 37 14 7AZ
.
Release screws (1).
Tightening torque 37 14 6AZ
.
Disconnect plug connection (4) and remove ride-height sensor.
Installation:
Sensor lever (2) must point outwards from ride-height sensor.
After installation:
•
E61: Carry out ride-height-calibration
•
Check headlight adjustment, correct if necessary
RA Replacing rear ride-height sensor
BMW AG - TIS
28.01.2013 00:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
