5 Series E60 523i (N52K) SAL
Necessary preliminary tasks:
•
Draw off and dispose of hydraulic fluid from fluid reservoir
•
Manual transmission incl. SMG: Relieve tension on drive belt
and remove from power steering pump belt pulley
•
Automatic transmission: Remove drive belt
Release bolts (1).
Tightening torque 32 41 5AZ
.
Automatic transmission: Detach bracket for hydraulic lines from oil
sump and slide downwards.
Unfasten banjo bolt (2).
Remove Dynamic Drive pressure line (3) with bracket from
power steering pump and lay to one side.
Installation:
Replace all sealing rings.
Make sure hydraulic line is laid without tension and with sufficient
spacing to adjoining components.
Tightening torque 32 41 3AZ
.
Unfasten hose clip (1).
Detach suction line (2) from power steering pump.
Automatic transmission: Detach bracket for hydraulic lines from oil
sump.
Unfasten banjo bolt (4).
Disconnect pressure line (3) from power steering pump.
Installation:
Replace all sealing rings.
Make sure hydraulic lines are laid without tension and with
sufficient spacing to adjoining components.
Tightening torque 32 41 3AZ
.
RA Removing and installing power steering pump for power steering gear with Dynamic
BMW AG - TIS
02.02.2013 17:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
