5 Series E60 523Li (N52) SAL
Important!
Aluminium-magnesium materials.
No steel screws/bolts may be used due to the threat of
electrochemical corrosion.
A magnesium crankcase requires aluminium screws/bolts
exclusively.
Aluminium screws/bolts must be replaced each time they are
released.
The end faces of aluminium screws/bolts are painted blue for
the purposes of reliable identification.
Jointing torque and angle of rotation must be observed
without fail (risk of damage).
Necessary preliminary tasks:
•
Remove front assembly protection.
•
Remove rear underbody protection.
•
Remove reinforcement plate
Important notes on installation are described in this work
step.
•
Remove complete exhaust system.
•
Remove heat shields and brackets.
Disconnect plug connection (1).
Release screws (2).
Remove cover plate (3).
Tightening torque, 24 00 1AZ.
Installation:
Release aluminium screw on right next to cable retaining plate
with special tool 00 9 010 .
Aluminium screws must be replaced.
Tightening torque 24 00 2AZ
.
RA Removing and installing automatic transmission (6HP19Z/N52/N52K/N53)
BMW AG - TIS
05.02.2013 20:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
