5 Series E60 523Li (N52) SAL
Prepare special tool (1) 24 4 161 (A) with shaped section (2)
24 4 165 side (A) to (A).
Insert special tool 24 4 160 into opening of transmission housing
and clamp gently with screw (1).
Twist in screw (2) and clamp down.
Then tighten down screw (1).
Release screws.
Installation:
Tightening torque, steel screws 24 00 1AZ
.
Aluminium screws must be replaced.
Tightening torque and angle of rotation
Aluminium screws (3, 4, 5, 9, 10) 24 00 2AZ
.
Screw 3 only on N54
Installation:
Secure angle of rotation special tool 00 9 120 with magnet
00 9 130 to floor plate.
Screw down aluminium screws according to angle of rotation.
Angle of rotation 24 00 2AZ
.
RA Removing and installing automatic transmission (6HP19Z/N52/N52K/N53)
BMW AG - TIS
05.02.2013 20:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -