5 Series E60 523Li (N52) SAL
51 14 110
Removing and installing/replacing rear model
designation
Important!
The "Instructions for number/letter combination cementing"
serve as the basis for these repair instructions and must be
followed without fail.
Fitting dimensions (E60, E61):
Stick on adhesive tape (1) between edge of rear lid (2) and top edge "A". Mark measurement "B" from top edge "A"
to outer edge of rear lid on adhesive tape (1).
Dimensions:
E60
A = 18 mm
B = 40 mm
E61
A = 17 mm
B = 31.5 mm
Note:
Measurements C, D and E are for information purposes only, as determined by carrier film.
520 i...540 i, 550 i:
C = 7 mm, D = 7 mm, E = 20 mm
RA Removing and installing/replacing rear model designation
BMW AG - TIS
06.02.2013 00:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -