5 Series E60 525d (M57T2) SAL
11 65 020
Removing and installing / replacing exhaust
turbocharger (M57T2)
Warning!
Scalding hazard!
Only perform these tasks on an engine that has cooled down.
Necessary preliminary tasks:
•
Remove right engine support arm
•
Remove primary catalytic converter
•
Remove right pressure pipe
•
Remove intake duct for intake noise damping
•
Disconnect clean air pipe between air-mass sensor and
turbocharger
Important!
In event of turbocharger damage:
•
Pressure pipes
•
Intercooler
•
Intake air manifold
must be checked for foreign bodies, damage and operation.
Release banjo bolt (1).
Installation:
Tightening torque 11 42 2AZ
.
Replace sealing rings.
Note:
Catch escaping engine oil in a suitable container.
Disconnect plug connection (2).
Release clamp (3).
RA Removing and installing / replacing exhaust turbocharger (M57T2)
BMW AG - TIS
09.02.2013 19:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
