5 Series E60 525d (M57T2) SAL
Disconnect connector (1).
Note:
Grip at hexagon head (2) when removing pressure sensor.
Release hexagon screw connection (3) on pressure accumulator.
Installation:
Secure position of pressure regulator and grip at hexagon
fitting (2).
Tighten down hexagon screw connection (3).
Installation:
Tightening torque 13 53 13AZ
.
Now clear the fault memory.
Installation:
Pressure regulator may only be used once.
Positioning before final tightening!
RA Replacing pressure regulator on pressure accumulator of fuel injection system (M
BMW AG - TIS
09.02.2013 20:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -