5 Series E60 525d (M57TU) SAL
Installation:
Clean rack.
Check surface of rack for damage (e.g. corrosion).
Replace O-ring (1).
Grease rack and O-ring (1) (refer to BMW Service Operating
Fluids).
On replacement, assemble new part with gaiter:
•
Determine measurement (A) on old part to simplify following
adjustment of front axle
•
Slacken clamping nut (2)
•
Screw off tie rod end; if necessary, grip tie rod with open-end
wrench
•
Remove clamping ring (1) and screw off clamping nut (2)
•
Slide gaiter (4) and ear clamp and band clamp (3) onto tie
rod
•
Slide clamping nut (2) and clamping ring (1) onto tie rod
•
Screw tie rod end onto tie rod to measurement (A)
•
Tighten down clamping nut (2)
Tightening torque 32 21 5AZ
.
After installation:
•
Only if replacing/removing tie rod end: Perform chassis
alignment check
•
Carry out steering angle sensor adjustment/adjustment for
active front steering
RA Replacing (removing and installing) left or right tie rod
BMW AG - TIS
11.02.2013 15:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
