5 Series E60 525d (M57TU) SAL
32 41 037
Removing and installing power steering pump
for power steering gear with Dynamic Drive
(M57TU, M57T2)
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Close off pipe connections with plugs.
Note:
When replacing power steering pump:
Fluid reservoir must be replaced in event of metal abrasion,
sluggish pump shaft or increased wear!
The filter integrated in the fluid reservoir can only absorb a limited
amount of foreign particles. If the filter clogs, the hydraulic system
can no longer be sufficiently protected.
Metal abrasion is perceived in the fluid reservoir as metallically
glittering hydraulic fluid.
It is only necessary to replace the fluid reservoir because of leaks
(e.g. at hose connections) only in the event of the unavoidably
high ingress of dirt.
Necessary preliminary tasks:
•
Draw off and dispose of hydraulic fluid from fluid reservoir
•
Release fluid reservoir and place to one side
•
Detach coolant expansion tank and place to one side
•
Remove alternator
•
Remove left pressure pipe
RA Removing and installing power steering pump for power steering gear with Dynamic
BMW AG - TIS
11.02.2013 16:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
