5 Series E60 525d (M57TU) SAL
1.
Thoroughly clean fluid reservoir and its immediate
surroundings
2.
Check and correct fill level
Note: The fill level can come to rest above the "MAX" mark
when the engine is at normal operating temperature. This is
dictated by the design in that the marking on the dipstick is
referred to a fluid temperature of 20
°
C. With the engine at
normal operating temperature (approx. 50-60
°
C fluid
temperature) adjust a fill height 15 mm above the "MAX"
mark. Do not under any circumstances draw off the fluid to
the "MAX" mark when the engine is at normal operating
temperature.
Hydraulic fluid: BMW Service Operating Fluids
3.
Start engine
4.
Turn steering wheel left and right twice in each case up to full
lock; if necessary, top up hydraulic fluid (e.g. if hydraulic
system is completely drained)
5.
Move steering wheel to straight-ahead position and turn off
engine
6.
Check and correct fill level with engine stopped
7.
Check hydraulic system for leaks
After filling:
•
If necessary, carry out initial Dynamic Drive operation
RA Bleeding power steering (version with Dynamic Drive)
BMW AG - TIS
11.02.2013 16:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
