5 Series E60 525d (M57TU) SAL
37 14 055
Removing and installing/replacing DYNAMIC
DRIVE control unit
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Necessary preliminary tasks:
•
Disconnect battery negative lead
•
Remove trim for instrument panel, bottom left
•
Remove side trim in front right footwell
Disconnect plug connection (1).
Release nut (2) and nut (concealed) above control unit.
Tightening torque 37 14 24AZ
.
Pull out Dynamic Drive control unit towards bottom.
After installation:
•
Replacement only: Carry out programming/coding
•
Carry out steering angle sensor adjustment/adjustment for
active front steering
•
Only when replacing / programming / coding: Carry out initial
DYNAMIC DRIVE operation.
RA Removing and installing/replacing DYNAMIC DRIVE control unit
BMW AG - TIS
11.02.2013 18:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
