5 Series E60 525d (M57TU) SAL
51 14 110
Removing and installing/replacing rear model
designation (Brilliance)
Important!
The "Instructions for number/letter combination cementing"
serve as the basis for these repair instructions and must be
followed without fail.
Attach adhesive tape (1) between edge of rear lid (3) and top
edge measurement "A".
Mark measurement "B" from outer edge of rear lid on adhesive
tape (1) and stick on adhesive tape (2) vertically.
Measurements E60:
A = 18 mm
B = 38 mm
Measurements E90:
A = 25 mm
B = 46 mm
Pull off liner (protective strip for adhesive surface).
Position characters on adhesive tapes (1 and 2) and stick into
place.
RA Removing and installing/replacing rear model designation (Brilliance)
BMW AG - TIS
11.02.2013 19:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
