bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

3 RA Removing And Installing Or Replacing Battery|Page 2333 > < 2 RA Performing Battery _power Reset_ (for Programming_coding Control Unit(s))
Page 1
background image

61 21 010

Removing and installing or replacing battery

Warning!

Observe safety instructions for handling vehicle battery.

Observe notes on power supply / on intelligent battery sensor
(IBS).

Necessary preliminary tasks:

Disconnect battery negative lead

Security version:

Remove protective cover from distribution box/battery positive

terminal (luggage compartment)

Disconnect plug connection (1) of IBS cable.

Unscrew nut (3). Tightening torque  61 21 1AZ

.

Important!

Do not under any circumstances pull/lever safety battery
terminal (2) off by force.

Detach safety battery terminal (2) towards top, lay to one side
and secure.

Release nuts (4) and remove rollover protection (5).

Release threaded pin (1) and remove holder (2).

Detach vent (4) in direction of arrow.

Fold both clips (3) open.

Pull battery (5) back from front fixture and remove towards top.

Installation:

Make sure battery (5) is correctly seated in front fixture.

RA  Removing and installing or replacing battery

BMW AG - TIS

12.02.2013  02:26

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

3 RA Removing And Installing Or Replacing Battery|Page 2333 > < 2 RA Performing Battery _power Reset_ (for Programming_coding Control Unit(s))