5 Series E60 525d (M57TU) SAL
Slacken screws (1)
Release screw (2).
Installation:
Tightening torque 65 77 5AZ
.
Raise B-pillar sensor (3) slightly through opening in B-pillar and
feed out towards rear.
Unclip cable duct (4) at points (5).
Unlock plug connections (1) and disconnect.
Feed B-pillar sensor (2) in direction of arrow out of B-pillar (3)
and remove.
Installation:
Make sure electrical leads are correctly routed.
Installation:
Make sure metal nut (1) is correctly positioned on B-pillar
sensor (2).
Replacement:
Carry out programming/coding.
RA Removing and installing (replacing) left B-pillar sensor
BMW AG - TIS
12.02.2013 06:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
