5 Series E60 525i (N52) SAL
12 14 521
Replacing crankshaft pulse generator (N52,
N52K, N51, N53)
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Important!
Aluminium-magnesium materials.
No steel screws/bolts may be used due to the threat of
electrochemical corrosion.
A magnesium crankcase requires aluminium screws/bolts
exclusively.
Aluminium screws/bolts must be replaced each time they are
released.
The end faces of aluminium screws/bolts are painted blue for
the purposes of reliable identification.
Jointing torque and angle of rotation must be observed
without fail (risk of damage).
Necessary preliminary tasks:
•
Read out fault memory of DME control unit
•
Switch off ignition
Note:
Installation location of pulse generator for crankshaft is
underneath starter motor.
Preparatory tasks:
•
Remove intake air manifold
RA Replacing crankshaft pulse generator (N52, N52K, N51, N53)
BMW AG - TIS
15.02.2013 05:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -