5 Series E60 525i (N52) SAL
72 12 010
Removing and installing/replacing airbag
module on left or right front door
Warning!
Read and comply with safety regulations for handling airbag
modules and pyrotechnical belt tensioners.
Incorrect handling can activate airbag and cause injury.
Front and rear airbag modules must not be mixed up.
Necessary preliminary tasks:
•
Disconnect battery cable
Follow instructions for disconnecting and connecting battery.
•
Remove front door trim
Unfasten screws.
Carefully remove airbag module.
Installation:
Before installing airbag module, remove all foreign bodies
(screws, etc.) from installation recess.
Replace screws.
Tightening torque 72 12 01AZ
.
Important!
Danger of mix-up with airbag module of rear door.
Difference:
-
Coded plug
If the plug does not fit on the module, check whether a
module was installed for the rear door.
-
"VORN / FRONT" and "HINTEN / REAR" printed on
RA Removing and installing/replacing airbag module on left or right front door
BMW AG - TIS
16.02.2013 05:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -