5 Series E60 525i (N52K) SAL
37 20 505
Removing and installing/replacing DYNAMIC
DRIVE holder/valve block
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Seal off pipe connections with plugs.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
•
If necessary, carry out initial operation for Dynamic Drive
Necessary preliminary tasks:
•
Remove valve block
Release screws (1).
Tightening torque 37 14 20AZ
.
Take off holder (2).
RA Removing and installing/replacing DYNAMIC DRIVE holder/valve block
BMW AG - TIS
17.02.2013 17:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
