5 Series E60 525i (N53) SAL
31 35 000
Removing and installing/replacing front
stabilizer
Necessary preliminary tasks:
•
Remove front assembly underside protection
•
If necessary, remove wheel suspension cover on both sides
•
Remove stabilizer link on both sides from stabilizer
If necessary, remove holder for hydraulic lines from retaining
bracket.
Release nut (1) and screw (2) at both ends.
Remove stabilizer from front axle carrier.
Installation:
Check both rubber mounts for damage, replace if necessary.
Replace self-locking nuts.
Tightening torque 31 35 1AZ
.
Replacement:
Remove rubber mount on both sides from stabilizer.
RA Removing and installing/replacing front stabilizer
BMW AG - TIS
18.02.2013 02:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -