5 Series E60 525xd (M57T2) SAL
13 62 533
Replacing primary catalytic converter
temperature sensor (M57T2)
Necessary preliminary tasks:
•
Read out fault memory of DDE control unit; if necessary, work
through test schedules
•
Switch off ignition
•
E83 only: If necessary, remove windscreen washer fluid
reservoir
•
E83 only: Remove rear underbody protection
Warning!
Scalding hazard!
Only perform this task on an engine that has cooled down.
Unlock plug (1) and remove.
Unclip cable.
Release temperature sensor (1).
Installation:
Tightening torque 13 62 1AZ
.
RA Replacing primary catalytic converter temperature sensor (M57T2)
BMW AG - TIS
20.02.2013 06:27
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
