5 Series E60 525xd (M57T2) SAL
Release screws.
Remove transmission cross-member.
Tightening torque 27 00 10AZ
.
Disconnect plug-in connections (1) and (2).
-
Remove propeller shaft from transmission.
-
Release centre bearing.
-
Tie propeller shaft to one side.
Tasks are described in Removing propeller shaft.
Note:
Pressure line of clutch slave cylinder remains connected.
Important!
Slowly relieve tension on clutch slave cylinder otherwise air is
drawn in through sealing sleeve.
Release nuts and remove clutch slave cylinder.
Tightening torque 21 52 5AZ
.
RA Removing and installing transmission (GS6-53DZ) AWD (M57T2)
BMW AG - TIS
20.02.2013 08:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
