5 Series E60 525xd (M57T2) SAL
-
Remove transmission cross-member
-
Remove propeller shaft from transmission.
-
Release centre bearing.
-
Tie propeller shaft to one side.
Tasks are described in Removing propeller shaft.
Disconnect plug-in connections (1) and (2).
•
Unlock and disconnect plug (1) by turning.
•
Release cable from retainers.
•
Insert special tool 24 2 390 in sealing sleeve.
These tasks are described in Notes on mechatronics.
(Important: Observe important note)
Release screw (1).
Disconnect hydraulic lines (2) to transmission fluid cooler.
Installation:
Replace sealing rings.
Note:
Illustration similar
RA Removing and installing automatic transmission (6HP26Z) AWD M57T2
BMW AG - TIS
20.02.2013 08:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
