5 Series E60 525xd (M57T2) SAL
27 10 070
Replacing output flange on transfer case at
rear (ATC300)
Important!
After completing work, check gear oil level and top up if
necessary.
Use only the approved gear oil in this transfer case.
Note:
•
Operations for removing output flange are identical to
replacing radial shaft seal
Installation:
•
Thickness of new shim must be determined before output
flange is installed
Determine and note down measurement A of output flange
(previous and new).
Determine and note down measurement B of output flange
(previous and new).
RA Replacing output flange on transfer case at rear (ATC300)
BMW AG - TIS
20.02.2013 09:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
