5 Series E60 525xd (M57T2) SAL
31 11 001
Replacing front axle carrier (AWD)
Warning!
Danger to life!
Secure engine in installation position to prevent it from falling
down.
Danger of poisoning if oil is ingested/absorbed through the
skin!
Risk of injury if oil comes into contact with eyes and skin!
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Seal off hydraulic lines with plugs.
Necessary preliminary tasks:
•
Disconnect battery negative lead
•
Draw off and dispose off hydraulic fluid from fluid reservoir
•
Secure engine in installation position
•
Remove front wheels
•
Remove stabilizer
•
Remove reinforcement plate
•
Remove steering gear cover on both sides
•
Remove lower steering spindle from power steering gear
•
If necessary, disconnect plug connection from EH converter
and remove line from front axle carrier
•
If necessary, remove ride-height sensor with line from front
axle carrier
•
If necessary, unclip vacuum line for engine mount from
engine support arm and disconnect
•
Remove both tension struts from front axle carrier
•
Remove both control arms from front axle carrier
•
Remove both tie rod ends from swivel bearing
•
Lower front axle carrier until power steering gear rests on
output shaft
•
Remove power steering gear
RA Replacing front axle carrier (AWD)
BMW AG - TIS
20.02.2013 09:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
