5 Series E60 525xd (M57T2) SAL
Centering pin missing: Make position of studs in relation to wheel
arch.
Secure spring strut against falling out.
Unscrew nuts.
Remove spring strut with swivel bearing downwards out of wheel
arch.
Installation:
Clean contact surface in spring strut dome.
Replace faulty sealing washer for spring strut support bearing
(corrosion protection).
Align spring strut using centering pin to bore in wheel arch or
studs to wheel arch and push upwards.
Replace self-locking nuts.
Tightening torque 31 31 1AZ
.
After installation:
•
Carry out wheel alignment check if a spring strut with support
bearing was or has been installed without centering pin.
RA Removing and installing complete front left or right spring strut (AWD)
BMW AG - TIS
20.02.2013 09:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
