5 Series E60 525xd (M57T2) SAL
31 60 ...
Press right output shaft approx. 6 to 7 cm out
of front differential
Special tools required:
•
31 5 110
Necessary preliminary tasks:
•
Remove tie rod end from swivel bearing
•
Remove tension strut from guide joint
•
Remove control arm from swivel bearing
Press output shaft with special tool 31 5 110 out of front
differential.
Insert spacer between bearing block and output shaft and secure
with adhesive tape.
Installation:
Push output shaft over resistance of snap ring. Output shaft must
snap audibly into place.
Important!
High installation forces indicate that the spline teeth on the
output shaft/rear differential side gear are damaged/deformed!
Check spline teeth, replaced damaged parts.
RA Press right output shaft approx. 6 to 7 cm out of front differential
BMW AG - TIS
20.02.2013 09:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
