5 Series E60 525xd (M57T2) SAL
N52: Remove gaiter with resonator.
M57T2: Remove steering gear cover at side.
Release clamping screw (1).
Move power steering gear into zero setting.
Note:
The markings on the cap and housing must match up (see arrow).
Remove ignition key.
Detach steering spindle lower section (2) from power steering
gear.
Installation:
Clean thread to remove all remnants of screw securing adhesive.
Replace clamping screw.
Tightening torque 32 31 1AZ
.
Release screws (1).
Tightening torque 32 31 17AZ
.
Remove steering spindle lower section (2).
Observe installation sequence:
1.
If necessary, move power steering gear into zero position or
steering wheel into straight-ahead position
2.
Slide steering spindle lower section (1) through sleeve (3)
3.
Slide double joint (2) into steering spindle lower section (1)
4.
Attach steering spindle lower section (1) to power steering
gear
5.
Attach double joint (2) to steering column
RA Removing and installing / replacing steering spindle lower section (AWD)
BMW AG - TIS
20.02.2013 10:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
