5 Series E60 525xd (M57T2) SAL
34 31 181
Removing and installing / replacing
expansion tank for hydraulic brake actuation
Necessary preliminary tasks:
•
Remove lower section of microfilter housing.
•
Read and comply with General Information.
Suck the brake fluid out of the expansion tank. Use suction bottle
exclusively to draw off brake fluid.
Important!
Do not reuse drawn out brake fluid.
Unfasten plug connection (1) and disconnect.
Release retaining screw (2).
Installation:
Tightening torque 34 31 3AZ
.
Pull expansion tank vertically out of brake master cylinder.
Installation:
Check rubber plug in brake master cylinder for damage and
replace if necessary.
Push the expansion tank vertically onto the master brake cylinder.
RA Removing and installing / replacing expansion tank for hydraulic brake actuation
BMW AG - TIS
20.02.2013 11:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
