5 Series E60 525xd (M57T2) SAL
Open weld joints in areas (1).
Open weld joints in area (1).
Mark severance cut according to measurement a and cut inside
A-pillar.
Measurement a = 47 mm from centre of bore.
Note:
When replacing right wheel arch:
Measurement a = 65 mm from centre of bore.
Measurement b = 20 mm
Different riveting-down elements, depending on the equipment
specification, must be mounted on the new component.
Required tools are featured on the Workshop Equipment Planning
CD (WEP).
See also Aftersales Assistance Portal (ASAP) -
Service/Technology - Workshop Equipment (Start BMW) - Shop
Workshop Equipment
RA Replacing front section of engine support to left wheel arch
BMW AG - TIS
20.02.2013 12:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
