5 Series E60 525xd (M57T2) SAL
Preparation of new part:
Mark severance cuts (1) on new part in accordance with previous severance cuts and cut.
Important!
Cut only outer plate at severance cut (2).
Measurement a = 80 mm below severance cut (2).
Open weld joints on sheet panel (3) and remove component.
Installation:
Cut-out sheet panel (3) is needed again to seal B-pillar.
Open weld joints on outer entrance attachment (4) between severance cuts and remove component.
RA Replacing cover for longitudinal member with left or right door pillar (partial
BMW AG - TIS
20.02.2013 12:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
