5 Series E60 525xd (M57T2) SAL
Open weld joints in areas (1).
Open adhesive bond in area (2).
Installation:
Plug weld in area (2).
Open weld joints in areas (1).
Open adhesive bond in area (2).
Installation:
Plug weld in area (2).
Mark severance cut in accordance with measurement a and cut
frame side member on left and right.
Measurement a=150 mm from center point of bore with dia.
20 mm.
Installation:
Weld in reinforcing panel at all severance cuts.
Open weld joints in areas (1) and (2) on both sides of vehicle.
Important!
Do not shorten height of bushing in area (2).
Grind bushing down to nominal diameter only.
RA Replacing complete rear luggage compartment floor (tail panel removed)
BMW AG - TIS
20.02.2013 12:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
