5 Series E60 525xd (M57T2) SAL
72 12 015
Removing and installing/replacing airbag
module on left or right rear door
Warning!
Read and comply with safety regulations for handling airbag
modules and pyrotechnical belt tensioners.
Incorrect handling can activate airbag and cause injury.
Front and rear airbag modules must not be mixed up.
Necessary preliminary tasks:
•
Disconnect battery cable
Follow instructions for disconnecting and connecting battery.
•
Remove rear door trim
Unfasten screws.
Carefully remove airbag module.
Installation:
Before installing airbag module, remove all foreign bodies
(screws, etc.) from installation recess.
Replace screws.
Tightening torque 72 12 01AZ
.
Important!
Danger of mix-up with airbag module of front door.
Difference:
-
Coded plug
If the plug does not fit on the module, check whether a
module was installed for the front door.
-
"VORN / FRONT" and "HINTEN / REAR" printed on
RA Removing and installing/replacing airbag module on left or right rear door
BMW AG - TIS
21.02.2013 02:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
