5 Series E60 528i (N52K) SAL
Installation:
Seal new component from inside in area (1) with sealing
compound.
Installation:
Reinforcement of C-pillar latch striker is originally bonded to outer
wheel arch. Drill holes for spot welding in contact surface of
reinforcement (1). Adjust side panel to fit and weld holes above
wheel arch.
Note:
Following work steps apply to M5 only.
Preparation of new part:
Rear side panel must be trimmed.
1 = Body outer side
RA Replacing rear left side panel (partial replacement, longitudinal member cover b
BMW AG - TIS
21.02.2013 13:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -