5 Series E60 528i (N52K) SAL
f)
Pressing on seal:
-
Press on seal using a roller
-
Adhesive tape width up to 5 mm Application pressure approx.
5 N
-
Adhesive tape width up to 10 mm Application pressure approx.
10 N
Sliding sunroof seal only:
-
Press against seal strongly with a roller. Application pressure
approx. 70 N.
E36 sliding sunroof seal only:
-
Application pressure approx. 30 N.
-
Tear off tear-off lip at rear and side in area of narrower flange.
Note:
Firm thumb pressure has approx. 35 N/cm
2
3.
Checking rubber seal
-
Check the bonded seals for correct positioning and perfect adhesion. The bonding can be checked by
pressing back the sealing lip.
-
The force required to peel off the seal immediately after gluing must be greater than 10 N/cm.
RA Repair instructions for bonded seals
BMW AG - TIS
21.02.2013 18:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -